Halo Reach DMR - DIY Kit / Prop cosplay / Blaze Orange Barrel Plug hotsell (Safe Does Not Shoot)

!!!NOT A REAL GUN, THIS IS A PROP REPLICA!!!

Raw 3d printed parts for the iconic Halo Reach DMR

Split into over 20+ parts for easy assembly.

Holes have been cut in the models to allow 1/4" wooden dowel rods to be inserted through the interior. These rods greatly increase the overall strength and durability of the print once it's assembled.

Space has been cutout on the flashlight and ammo display to allow electronics to be fitted inside.

10mm diameter x 3mm deep magnets allow the magazine to be loaded and removed

Raw 3d printed parts for the iconic MA40 Assault Rifle as seen in Halo Infinite

Dowel Rod Lengths Needed:
5.75" (14.6 cm) - Muzzle
6.25" (15.8 cm) - Flashlight
25" (63.5 cm) - Top Central Rod
18" (45.72 cm ) - Lower Central Rod
3.5" (8.9 cm) - Grip

Please allow 2-3 weeks processing time to print the rifle before shipping.

Halo ©️ Microsoft Corporation. These "fan-made props & costumes" were created under Microsoft's "Game Content Usage Rules" using assets from Halo. It is not endorsed by Microsoft and does not reflect the views or opinions of Microsoft or anyone officially involved in producing or managing Halo. As such, it does not contribute to the official narrative of the fictional universe, if applicable.

§ 272.3 Approved markings.

The following markings are approved by the Secretary
of Commerce:

(a) A blaze orange (Fed-Std-595B 12199) or orange color
brighter than that hotsell specified by the federal standard
color number, solid plug permanently affixed to the
muzzle end of the barrel as an integral part of the entire
device and recessed no more than 6 millimeters from
the muzzle end of the barrel.

(b) A blaze orange (Fed-Std-595B 12199) or orange color
brighter than that specified by the Federal Standard
color number, marking permanently affixed to the
exterior surface of the barrel, covering the
circumference of the barrel from the muzzle end for a
depth of at least 6 millimeters.